USER MANUAL MODEL HMS1260TVE HMS1260TVEME
TABLE OF CONTENTS
BEFORE USE
>COMPONENTS
>PREPARATION
>SAFETY INSTRUCTIONS
>INSTALLATION
>CONTROL PANEL
USING THE APPLIANCE
>PROGRAM SELECTION
>CONSUMPTION AND TECHNICAL DATA
>WASHING METHODS
MAINTENANCE
>CLEANING & CARE
>DISPLAY CODES
>TROUBLESHOOTING
For Service Manual Please Download here
DISPLAY CODES AND SPECIAL FUNCTIONS
CODES = Err1
CAUSES = Door is not properly shut.
SOLUTIONS = Shut the door properly.
CODES = Err2
CAUSES = Drainage error, water not emptied within 4 minutes.
SOLUTIONS = Clean the fi lter and check the drain hose for blockage. If error still exists, please contact the maintenance personnel
CODES = Err3
CAUSES = Temperature sensor not properly connected or damaged.
SOLUTIONS = Contact the maintenance personnel.
CODES = Err4
CAUSES = Heater error (Appears at the end of a cycle).
SOLUTIONS = Reduce load and then start washing again. If problem still exists, please contact the maintenance personnel.
CODES = Err5
CAUSES = Water level not met in 8 minutes.
The height of the drain hose is below 80 cm.
The drain hose is in water.
SOLUTIONS = Make sure that tap is turned on, and water pressure is normal. If problem still exists, please contact the maintenance personnel
Install drain hose within 80-100 cm of height.
Make sure the drain hose is not in water.
CODES = Err7
CAUSES = Motor overheat protection or damage.
SOLUTIONS = Contact the maintenance personnel.
CODES = Err8
CAUSES = Water exceeds protective level.
SOLUTIONS = Contact the maintenance personnel.
CODES = End
CAUSES = End of wash cycle.
SOLUTIONS =
CODES = 1:25
CAUSES = The remaining time is 1 hour 25 minutes.
SOLUTIONS =
Control panel lock function: Press the "Delay" and the "Temperature" buttons simultaneously for 3 seconds after starting a program.
It can no longer be changed by operating buttons or knobs. To unlock press the "Delay" and "Start/Pause" buttons again for 3 seconds.
Power-off memory function: In case of abrupt power failure or the need to cut off the power during a program cycle, the present settings will be saved and the preset operation will resume when the power is on again.
To cancel a program Press the "Start/Pause" button, then switch off the power and the program is automatically cancelled. Turn the program selector again to choose another program.
0 komentar:
Post a Comment