Wednesday, August 31, 2011

Whirlpool Washing Machine Model AWM6100 Error Code



FAILURE DURING NORMAL OPERATION
If a failure is detected during normal operation, the machine will stop, the programme sequence
LED where the failure occurred will flash and the speed indicator LED's will illuminate in a
pattern to indicate the fault code.
FAULT CODES

Fault = 1
Detected Malfunction = Water not entering or not detected
Perform the following = Check tap, cold inlet valve, pressure switch

Fault = 3
Detected Malfunction = Drain failure or not detecting empty drum
Perform the following = Check pressure switch, blocked drain, drain pump

Fault = 5
Detected Malfunction = NTC failure
Perform the following = Check NTC

Fault = 6
Detected Malfunction = Tachometer failure (no motor movement detected)
Perform the following = Check motor

Fault = 7
Detected Malfunction = Circuit board failure (motor triac)
Perform the following = Replace timer

Fault = 9
Detected Malfunction = Drain failure
Perform the following = Check drain pump, pressure switch, blocked drain

Fault = 11
Detected Malfunction = Electronic failure
Perform the following = Replace timer

Fault = 14
Detected Malfunction = Electronic failure
Perform the following = Replace timer

Fault = 16
Detected Malfunction = Control failure
Perform the following = Replace timer

Fault = 18
Detected Malfunction = Control failure
Perform the following = Replace timer

Fault = 20
Detected Malfunction = Control failure
Perform the following = Replace timer

Fault = 21
Detected Malfunction = Control failure
Perform the following = Replace timer


Kindly Bookmark this Post using your favorite Bookmarking service:
Technorati Digg This Stumble Stumble Facebook Twitter
YOUR ADSENSE CODE GOES HERE

1 komentar:

Unknown on December 30, 2016 at 5:38 AM said...

where are this leds? on the Whirlpool AWT2288/3-800?

Post a Comment

 

| Code Error Washing Machine © 2014. All Rights Reserved | Template Style by My Blogger Tricks .com | Design by Brian Gardner | Back To Top |